Hi, I'm aware this question has been brought up previously via searching and I may just be not considering various factors due to being relatively new to this. On converting one of our machines I am consistently running into a bad block being reported which is valid, and reconfiguration failing at 98% (previously this was at 96% when I was trying to increase memory from 1 GB to 3, now keeping at 1).
Attached is the log I could manage exporting (inform me if another is required), from what I could discern though I may be offbase there is a failed read access error.
For reference this attempt was when I was converting using version 9, the most recent attempt not covered was with version 7.
I have seen suggested when I first was having the issue to edit boot.ini when I was trying to convert and increase memory to 3 GB but am very wary to do so.
Any suggestions would be appreciated.