Quantcast
Channel: VMware Communities: Message List - Converter Standalone
Viewing all articles
Browse latest Browse all 8478

Re: FAILED: An error occured while opening a virtual disk. Verify that the Converter server and the running source machines have a network access to the source and destination ESX/ESXi hosts.

$
0
0

I've been starting only one at the time, and it fails after 4-7 minutes with the message I've put in the headline of this thread:

  • FAILED: An error occured while opening a virtual disk. Verify that the Converter server and the running source machines have a network access to the source and destination ESX/ESXi hosts

 

 

I have attached the log from the sever that started running yesterday and then failed. The job starts at 08:55:54 PM and finishes at 0:52:33 PM.
The GUI error says:

  • FAILED: An error occured during the conversion: 'BlockLevelVolumeCLoneMgr::CloneVolume: Detected a write error during the cloning of volume \\WndowsBitmapDriverVolumeID=[2A-B0-4B-E3-00-00-10-00-00-00-00-00].Error: 37409 (type: 1, code: 2338)

 

Meanwhile, I've been able to start a convert operation of a 4th server, which only has 6TB total disk space. This is now running without any problems.

I then also tried converting a 5th server which has 8 TB total disk space, but it failed. If I only select the C: drive and one or two volumes (total of max 4TB), it works.


This might be a coincidence, but if you combine these two servers that are now running together, it's right below 10TB total. That's the same limit I experienced in the beginning. When choosing volumes on the same server that exceeds total disk space of 10TB, the job would fail.


Viewing all articles
Browse latest Browse all 8478

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>